ported that in the original layout (FCH pulsation damper, no restriction orifice plates) the maximum pressure pulsa One gas filled pulsation damper (gas.

The recommended nitrogen pressure setting for pulsation damping is 80% of If in doubt please contact FCH technical department direct. www.Laheghi.com 

Alleviators; Water Cooling; Diaphragm; Hydraulic Cooling; Attenuators; Oil Cooler; Pulsation Dampers; Hydraulic Cooler; Hydraulic Storage; Hydraulic Surge 

The body of the metallic ones can be manufactured in stainless steel AISI 316L, carbon steel or in special materials such as Duplex, Super Duplex, Hastelloy, titanium, and others. The volume range of s HIDRACAR bladder pulsation dampers is from 0.04 to 35 liters, available with design pressures of up to 1,000 bar. In addition to our standard

PULSATION DAMPERS SB non-permitted temperature increase and/or excessive pressure, we recommend our safety devices. You can find further information and an 

Comar are distributors and re-certification agents for the range of FCH A new range of pulsation dampers available in special steels and polypropylene.

The D-CFC Kit takes a traditional gas charge style dampener and converts it into a maintenance free pulsation solution. This allows you to upgrade your current hardware and start enjoying the benefits of both types of pulsation control. Your existing gas charge dampener is lightweight and has a small footprint, and our kit fits right inside.

a pulsation damper without the problems as the damping element and an elastomer SM50P-3.8A6/116FCF. SAE 2" – 3000 psi. SM50P-3.8A6/116FCH.

Generally, the application of pulsation dampers is based on one or more of the following criteria: Prevent potential pipe hammer / vibration. Reduce the load on the pump itself. Minimize or eliminate pulsations for the benefit of downstream instrumentation. Minimize or eliminate pulsations as a dictate of process.

In every pulsation dampener there is a separator element between the gas it is charged with and the liquid of the circuit; its basic function being to avoid the leaking of the gas into the circuit. This separator element is basically made of two kinds of materials: Rubber (NBR, EPDM, FPM, butyl, silicone, etc) or a thermoplastic material (normally PTFE); although it can also be made in

About Pulsation Dampeners. Pulsation dampeners are devices installed at the discharge side of reciprocating positive displacement pumps. They enhance hydraulic system performance and